Thou really It should be a Momentary button I could have put an on/off switch in the case NO switches are connected so you can still use the system.? Again can't remember.! Again can't remember has it's so long ago but I will probably have put a Limit override switch on the front so you can back off the limits when hit. This system won't reset unless everything is correct.? By this I mean limits are not tripped and E-stop released.Īlso It won't start if the NC limit switches are not connected. K4 if I connected it would have been for the spindle, but it's that long ago now I can't remember.? The system use's 24V for E/stop/Limits and uses 24V relays to control safety and in this case 2 relay boards using 2 x 2pdt relays working has one 4PDT, why.? Because it's all I had at the time. Phil If the all 3 lights are coming on then think you'll find it's working ok and chances are it's a setup issue inside Mach.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |